The elumo Hub should be installed as close to the elumo Reader as possible on the secure side of the door and may be installed with all wiring entering the hub from inside the wall.
For surface wiring in the ceiling or on the wall (where cables enter via side entry) please got to elumo Hub Installation (surface wiring).
Surface-mounted on the wall (cables via rear entry)
Use the mounting template provided to identify a suitable place on the wall to mount the hub, ensuring that the template is upright & level, and mark the mounting locations using the holes provided
Drill the mounting holes using a 6mm or 1/4" diameter drill bit
Drill out the cable entry area (marked B on the template) using a 25mm/1" hole saw or cut out as required
Remove the rear cable entry knock-out
Place the supplied fixings in the mounting holes
Mount the hub to the wall using the supplied screws
Route the cables into the elumo Hub
Connect the elumo reader and ethernet cables
Connect the wired electric lock to the relay
Hook the case lid on top of the hub and secure underneath using the supplied security screws